Table of Contents
Advertisement
00176566
Status light
Microphone
4.6.1 Product features
• Status LED is constantly lit red: Preparing for pairing
mode
• Status LED flashes red: Pairing mode active (device can
be connected)
• Status LED flashes blue: QR code was recognised
• Status LED is constantly lit blue: Connection set up
successfully
Note
• Protect the product from dirt, moisture and
overheating, and only use it in a dry environment.
• Connect the product only to a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
• Do not attempt to service or repair the product yourself.
Leave any and all service work to qualified experts.
• Do not continue to operate the device if it becomes
visibly damaged.
• The product is intended for indoor use only.
• Keep this product, as all electrical products, out of the
reach of children!
4.6.2 Installation
• You can attach the camera using adhesive pads.
• Power can be supplied to the camera only via USB.
• For USB operation, connect a Micro-USB cable (included
in delivery) to the Micro-USB port and to a suitable USB
power supply (included in delivery). Plug the power
supply unit into a socket. Connect the product only to a
socket that is approved for the device. The socket must
be installed close to the product and must be easily
accessible. When powering the device using a USB
power supply, make sure there are no batteries inside
the device.
14
SD card slot
Reset
Speaker
Micro USB
Warning - Installation with adhesive pad
• All parts are intended for indoor use only. Do not
install them outdoors.
• Please note that the installation surface you choose
should be free of dust and grease. Use a suitable clean-
ing agent from a specialised dealer to clean the surface.
• Note that the adhesive pad attachment is permanent.
To remove the adhesive pad, carefully pull it off the
installation surface.
• Various environmental factors such as ambient
humidity, sunlight or cold can impair the durability of
the adhesive pad.
• We cannot guarantee that residue will not be left on the
mounting surface after the adhesive pad is removed.
4.6.3 Integrating devices into the Hama Smart
Solution app
• Connect the WiFi camera to the USB cable supplied and
the power supply unit. Plug the power supply unit into
a socket.
• Wait a moment until the camera emits a signal tone and
the LED begins to flash red.
• Open the app and tap 'My home' at the lower-left edge
of the screen.
• Then tap '+' at the upper-right edge of the screen, select
the 'Cameras''.
• Tap 'OK' to confirm that the camera is flashing.
• Then enter the name of your WiFi network and the
password. Tap 'OK' to confirm your entries.
• Now scan the QR code with the camera. Tap 'I heard
the beep' to confirm that you heard a signal tone. The
camera will now be connected.
Advertisement
Table of Contents
