Integrating Devices In The Hama Smart Solution App - Hama 00176547 Operating Instruction

• If a door leaf or window sticks out, the sensor can also
be attached at the side, and the device can be attached
flat on the frame.
Warning - Installation with adhesive pad
• All parts are intended for indoor use only. Do not
install them outdoors.
• Please note that the installation surface you choose
should be free of dust and grease. Use a suitable clean-
ing agent from a specialised dealer to clean the surface.
• Note that the adhesive pad attachment is permanent.
To remove the adhesive pad, carefully pull it off the
installation surface.
• Various environmental factors such as ambient
humidity, sunlight or cold can impair the durability of
the adhesive pad.
• We cannot guarantee that residue will not be left on the
mounting surface after the adhesive pad is removed.
4.4.3 Integrating devices in the Hama Smart Solu-
tion app
Now insert the two AAA batteries supplied, observing
correct polarity. When you press the anti-theft protection,
the LED should briefly light up blue; if not, please replace
the batteries
10
Warning - Batteries
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking or
exploding.
• Only use batteries (or rechargeable batteries) that
match the specified type.
• Before you insert the batteries, clean the battery
contacts and the polar contacts.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries or batteries of a
different type or make.
• Remove the batteries from products that are not being
used for an extended period (unless these are being
kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a fire.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries
from the product.
• Avoid storing, charging or using the device in extreme
temperatures and extremely low atmospheric pressure
(for example, at high altitudes).
• Now press the Pairing button for 5 seconds. The LED
begins to flash red quickly. If it flashes slowly, press the
button again for 5 seconds.
• Open the app and log in.
• Press + in the upper-right corner to add a new device.
• Select Sensors in the list.
• Now confirm that the LED flashes quickly.