Table Of Contents - Toro Super Recycler 20383 Operator's Manual

fouling, hard starting, and increased emissions.
Once you have installed the kit, attach the
high-altitude label next to the serial decal on the
machine. Contact any Authorized Toro Service
Dealer to obtain the proper High Altitude Kit and
high-altitude label for your machine. To locate
a dealer convenient to you, access our website
at www.Toro.com or contact our Toro Customer
Care Department at the number(s) listed in your
Emission Control Warranty Statement.
Remove the kit from the engine and restore the
engine to its original factory configuration when
running the engine under 1500 m (5,000 ft). Do
not operate an engine that has been converted
for high-altitude use at lower altitudes; otherwise,
you could overheat and damage the engine.
If you are unsure whether or not your machine
has been converted for high-altitude use, look for
the following label:
Contents
Introduction ............................................................... 1
Safety ....................................................................... 3
General Safety ................................................... 3
Safety and Instructional Decals .......................... 4
Setup ........................................................................ 6
1 Installing the Blade-Control Bar........................ 6
2 Assembling and Unfolding the Handle.............. 6
3 Installing the Recoil-starter Rope in the
Rope Guide..................................................... 7
4 Filling the Engine with Oil ................................. 8
5 Assembling the Grass Bag............................... 8
Product Overview ..................................................... 9
Operation ................................................................ 10
Before Operation ................................................. 10
Before Operation Safety ................................... 10
Filling the Fuel Tank .......................................... 10
Checking the Engine-Oil Level...........................11
Adjusting the Cutting Height ..............................11
Adjusting the Handle Height ............................. 12
During Operation ................................................. 12
During Operating Safety ................................... 12
Starting the Engine ........................................... 13
Using the Self-Propel Drive............................... 13
Shutting Off the Engine..................................... 13
Engaging the Blade .......................................... 14
Disengaging the Blade...................................... 14
Checking the Blade-Brake-Clutch
Operation ...................................................... 14
Recycling the Clippings .................................... 15
Bagging the Clippings....................................... 16
Side-Discharging the Clippings......................... 18
Operating Tips ................................................. 18
After Operation .................................................... 19
After Operating Safety ...................................... 19
Cleaning under the Machine ............................. 19
Maintenance ........................................................... 21
Recommended Maintenance Schedule(s) ........... 21
Maintenance Safety.......................................... 21
Preparing for Maintenance ............................... 21
Servicing the Air Filter....................................... 22
Changing the Engine Oil ................................... 22
Lubricating the Wheel Gears ............................ 24
Replacing the Blade.......................................... 24
Cleaning the Blade-Brake-Clutch Shield ........... 24
Adjusting the Self-Propel Drive ......................... 25
Storage ................................................................... 26
Preparing the Machine for Storage ................... 26
Folding the Handle ........................................... 26
Removing the Machine from Storage ................ 26
decal127-9363
2