Toro Super Recycler 20383 Operator's Manual page 23

Figure 41
5. After draining the used oil, return the machine to
the operating position.
6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7. Wait about 3 minutes for the oil to settle in the
engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
10. Read the oil level on the dipstick
Figure 42
1. Full
2. High
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
g017475
(Figure 42).
g195250
3. Low
8 through 10 until the oil on the dipstick is at
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is at
the correct level.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick securely.
12. Recycle the used oil properly.
23