Bagging The Clippings - Toro Super Recycler 20383 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
Note:
Ensure the bag is seated in the correct position.
WARNING
A worn grass bag could allow small stones
and other similar debris to be thrown toward
you or bystanders, resulting in serious
personal injury or death.
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
If the side-discharge chute is on the machine, remove
it and lock the side-discharge door; refer to
the Side-Discharge Chute (page 18)
the clippings.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts
to stop before leaving the operating position.
Installing the Grass Bag
1. Route the starter rope around the lower-rope
guide (Figure 26).
Figure 26
1. Lower-rope guide
Note:
The lower-rope guide releases the starter
rope when you pull the recoil-start handle.
2. Raise and hold up the discharge door
27).
1. Discharge door
Removing
3.
before bagging
4.
1. Discharge door
5.
Removing the Grass Bag
g017473
1.
(Figure
16
Figure 27
Pull out the rear-discharge plug
Hang the upper front edge of the bag on the
notches (Figure 28).
Figure 28
Note:
Ensure that the grass bag is securely
installed onto the machine.
Lower the discharge door.
Route the starter rope around the lower-rope
guide (Figure 29).
g017464
2. Rear-discharge plug
(Figure 27).
g017474
2. Grass bag