England's Stove Works 25-CAB80 Installation & Operation Manual page 48

Igniter
 Before beginning any component replacement, be certain the unit is unplugged and
thoroughly cooled down.
 Remove the back panel of the unit, using a 5/16" wrench.
 Locate the igniter on the left side of the feeder assembly (as viewed from the rear of the
unit).
 Disconnect the power leads to the igniter.
 Loosen the 5/16" square head set screw from the igniter tube and remove the old igniter
cartridge (your unit may have Allen set screw which needs a
 Install the new igniter in the igniter tube, being sure the igniter is flush with the back of the
housing.
 Retighten the set screw and remember to reconnect the power leads.
 Reinstall the rear panel.
 See youtube.com/heatredefined for a service video that shows how to replace the igniter.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
REPLACING COMPONENTS
Set
Igniter
Screw
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
1
/
48
" Allen wrench).
8