England's Stove Works 25-CAB80 Installation & Operation Manual page 19


Top Mount boards: when the "ON" button is pressed, the board will scroll the message "DID YOU CLEAN
BURN POT BEFORE STARTING? HOLD ON TO CONFIRM". Press and hold the "ON" button for 3 seconds to
start the unit.

Side Mount boards: Shortly after pressing the "ON" button, the letters "S U" will appear in the display
windows of the board. This indicates the stove has entered the start‐up sequence and is operating normally.

After initiating the start‐up as described above, the most recent setting will appear in the window of the control
board (Side Mount boards will continue to show "S U"). This indicates the stove has entered the start‐up sequence
and is operating normally.

The fuel feed rate and combustion air during start‐up is determined by the control board, so the stove may be
started on any heat range.
 After approximately fifteen minutes, the fire should be burning brightly. At this point, the stove has begun
normal operation and the display windows on the control board will display your setting, unless the board
is adjusted.
 It is normal for the unit to smoke during the first fire, as paints and oils cure. This should dissipate within
the first hour. Open a door and/or window during the first fire to ventilate the area.
Daily Operation Notes
 Only high quality, Premium Grade ¼" (.25 in.) diameter wood pellets should be used in this stove.
Using low grade wood pellets with high ash content OR wood pellets with a high moisture content
can cause the burn pot to fill with ash at a more rapid pace and can cause intervals between
periodic maintenance to become significantly shorter. Please read the "Maintenance" section of
this manual thoroughly to understand how fuel selection affects stove operation, maintenance
and cleaning.
 Variation in the flame height is normal; not all wood pellet fuel is uniform in size, which can affect
the way pellets are fed into the burn pot. Although the flame height may increase and decrease
during operation, there is no loss of efficiency.
 Always store wood pellet fuel in a dry location; storing wood pellet fuel in a dry location ensures
the fuel will remain pelletized and low in moisture content. Also, be certain that all wood pellet
fuel is stored at a safe distance from the pellet heater; storing fuel in close proximity to the stove
can result in a fire. Do not install or operate this unit outside, in a greenhouse, or in any area
that is high in moisture.
 This pellet burning room heater is equipped with a specially designed burn pot which comes
preinstalled from the factory. This burn pot elevates the burning pellets and delivers air at the
precisely‐required locations. Pellets must only be burned in the factory burn pot; no modifications
should be made to this burn pot and no additional grates or other fire elevators should be used.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
19