Table of Contents
Advertisement
Quick Links
Petrol Lawnmower
125 cc
Manufacturer:
3 Sheldon Square
London
W2 6PX
United Kingdom
Distributor: B&Q plc
Chandlers Ford, Hants,
SO53 3LE United Kingdom
www.diy.com
SFD Limited
Trade House, Mead Avenue
Yeovil
BA22 8RT, UK
MLMP450HP40
EAN: 3663602939528
WARNING: Read the instructions
before using the product
Advertisement
Table of Contents
Related Manuals for Mac allister MLMP450HP40
Summary of Contents for Mac allister MLMP450HP40
- Page 1 3 Sheldon Square London W2 6PX United Kingdom Distributor: B&Q plc Chandlers Ford, Hants, SO53 3LE United Kingdom www.diy.com SFD Limited Trade House, Mead Avenue Yeovil BA22 8RT, UK MLMP450HP40 EAN: 3663602939528 WARNING: Read the instructions before using the product...
- Page 2 Safety information MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Safety warnings Let’s Petrol powered lawnmowers safety warnings get started... IMPORTANT Read carefully before use. Keep for future reference. Training 1. Read the instructions carefully. Be familiar with the controls These instructions are for your safety. Please read through and the proper use of the product.
- Page 3 Safety information Safety information MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister • Add fuel before starting the engine. Never remove the cap 6. Walk, never run. of the fuel tank or add petrol while the engine is running or 7. Mow across the face of slopes, never up and down.
- Page 4 Safety information Safety information MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister 20. Do not tilt the product when starting the engine or switching 28. Never carelessly touch the product, you can burn yourself. on the engine, except if the product has to be tilted for While the product is in operation or shortly thereafter, its starting.
- Page 5 Safety information Safety information MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister 10. Wear strong work gloves when removing and re-assembling Vibration and noise reduction the cutting device. To reduce the impact of noise and vibration emission, limit the 11. Always replace worn or faulty parts with the genuine parts.
- Page 6 Safety information Safety information MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Symbols spark plug connector. immediately if the product switch is no longer accessible. the following symbols and abbreviations. Familiarise yourself with them to reduce hazards like personal injuries and damage to property.
- Page 7 Safety information Safety information MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Mow across the face of slopes, never up and down. Inspect the area where the product is to be used and remove all objects Do not expose the product to rain or wet conditions.
-
Page 8: Your Product
Your product Your product MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Your product 1. Handle Spring washer 2. Brake bar Cap nut 3. Upper handle bar 4. Brake wire 20. Grass catcher 5. Lower handle bar Handle 6. Locking knob Hatch 7. - Page 9 Your product Before you start MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister The sound values have been determined according to noise test code given in EN ISO 5395-2, using the basic standards ISO 3744 and ISO 11094. General Wear hearing protection, especially when sound pressure is over 80 dB(A).
-
Page 10: You Will Need
Before you start Before you start MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister You will need 2. Ensure that the levers (6a) are released and unfold the upper and lower handle (Fig. (items not supplied) (items supplied) > Suitable personal protective equipment >... -
Page 11: Fuel And Engine Oil
Before you start Before you start MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister 7. Unfold the upper handle bar and use the locking knob (6a) positions for height adjustment of the handle (Fig. 5). Fig. 8. Fix the wires with the wire clip to the lower handle bar (Fig. - Page 12 Before you start Before you start MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister NOTE: you use petrol which has been kept for more than days. WARNING! Towards the end of the season, it is advisable to put only as much fuel in the tank as you need for each use, since it should be completely used up before storing the product.
-
Page 13: Operating Controls
Quick start Quick start MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Operating controls Set up Assemble Adjust Add fuel Add oil Start rope guide Pull recoil starter Press primer Pull and hold brake sharply, repeat until Operate times engine starts Stopping... -
Page 14: Intended Use
MLMP450HP40 By MacAllister Intended use This petrol lawnmower MLMP450HP40 is designated with a power output of 1.7 kW. 1. The product is intended for mowing grass in domestic gardens only. It must not be used to mow unusually high, dry or wet grass, e. g. pasture grass; for shredding leaves or mulching. -
Page 15: Grass Catcher
Product functions Product functions MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister 2. Slowly pull on the recoil starter handle (22) (Fig. Emptying (21) on the right hand side of the upper handle during operation (Fig. 12). Do not Empty the grass catcher (20) frequently during use. -
Page 16: Mulching Insert
Product functions Operation MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Mulching insert The primer (10) (11). Use the primer (10) when starting the product with cold engine (Fig. 17) For mulching work use the mulching insert (27). (19), hold it in position and insert the mulching insert... - Page 17 Operation Operation MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Starting/Stopping WARNING! Clean the underside of the deck! Keep yourself ready! Start the engine carefully according to instructions. Keep your feet well away from the blade! Do not tilt the product when starting the engine.
-
Page 18: After Use
Operation Operation MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister 5. Mow in slight overlapping rows. The most effective pattern for mowing lawns is Mulching straight lines along one of the sides. This will keep the rows even and ensures that all the lawn is cut without missing any spots (Fig. 20). -
Page 19: General Cleaning
Care and maintenance Care and maintenance MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister The golden rules for care Maintenance Before and after each use, check the product and accessories (such as application WARNING! Always switch the product off, disconnect the spark plug connector tools) for wear and damage. - Page 20 Care and maintenance Care and maintenance MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Refer to the B&S operator’s manual for maintaining below parts: NOTE: Replace this cutting device after hours mowing or years whichever > > Carburettor is sooner regardless of condition. If the cutting device is cracked or damaged, >...
-
Page 21: Troubleshooting
Trouble shooting Trouble shooting MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Trouble shooting Problem Possible cause Solution 4. Engine 4.1 Spark plug is defective 4.1 Install new, correctly gapped operates plug Therefore check the product using this section. In most cases the problem can be erratically 4.2 Spark plug gap is incorrect... -
Page 22: Recycling And Disposal
Recycling and disposal/Guarantee EC declaration of conformity MLMP450HP40 By MacAllister MLMP450HP40 By MacAllister Recycling and disposal EC declaration of conformity 1. Old products are potentially recyclable and do not, therefore, belong in your household rubbish. You are requested to assist us and our contribution to saving resources and protecting the environment by handing in this product at an equipped collection centre (if there is one available).