Suction­control - Grundig VCC 7570 C Instruction Manual

Multi-cyclonic vacuum cleaner
Table of Contents

Advertisement

Available languages

Available languages

OPERATION __________________________
1
Pull out the the power cord to the required
length.
Caution
A yellow mark on the power cord indicates the
recommended cord length. Never try to extend
the cord length beyond the red mark.
2­Insert the power cord plug into the wall socket.
3­Switch on the appliance by pressing the
On/Off button
.
C
4­Set the required suction power with the power
adjustment controller.
Note
You can hold the vacuum cleaner by the
carrying handle
B
make sure that the appliance is switched off
before carrying.
5­After use, press the On/Off button
off the appliance and remove the power cord
plug from the wall socket.
Caution
Always disconnect the mains plug from the
wall socket when the appliance is not in use.
6
Hold the power cord in one hand and press
and hold the power cord rewind button.
7­Carefully guide the power cord back into the
appliance.
10 ENGLISH
to move the appliance, but
to switch
C
Caution
Always rewind the power cord with care
as pressing one side of the button at a high
rewinding speed can cause unforeseeable
cable movements.
Suction­control
The suction control
L
and can be operated with your thumb. When
the control is fully closed, the maximum suction
power is reached.
However, in some cases it is advisable to have
less suction power, such as when cleaning
material, upholstery or shag pile carpets. Open
the control if and when required.
is located on the handle

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vcc 7570 a

Table of Contents