PowerDsine 6001 User Manual

1-port power over lan hub

Advertisement

Quick Links

Safety Information (cont.)
~
WARNING
Read the installation instructions before connecting
the Power over LAN Hub to its power source.
~
WARNING
Follow basic electricity safety measures whenever
connecting the Power over LAN Hub to its power source.
~
WARNING
This product relies on the building installation for
short-circuit (over current) protection. Ensure that a
fuse or circuit breaker no larger than 120 VAC, 3A.
U.S. (240 VAC, 1.5A international) is used on the
phase conductor.
WARNING
~
A voltage mismatch can cause equipment damage
and may pose a fire hazard. If the voltage indicated
on the label is different from the power outlet voltage,
do not connect the Power over LAN Hub to this
power outlet.
~
WARNING
The Power over LAN Hub "Data In" and "Data &
Power Out" ports are shielded RJ-45 data sockets.
They cannot be used as Plain Old Telephone
Service (POTS) telephone sockets. Only RJ-45 data
connectors may be connected to these sockets.
2002 PowerDsine
All Rights Reserved.
P/N Y1-6040-010
Rev. A0
1-Port
Power over LAN
Hub
User Guide
Notice
It is PowerDsine's policy to improve its products as
new technology, components, software, and
firmware become available. PowerDsine, therefore,
reserves the right to change specifications without
prior notice.
Trademarks
The product described in this guide is a licensed product of
PowerDsine.
Power over LAN
is a trademark of PowerDsine Ltd.
Technical Support
If you encounter problems when installing or using this
product, please consult the PowerDsine website at:
http://www.powerdsine.com
If these resources don't provide the help you need,
please contact your local authorized PowerDsine
reseller for additional technical support.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6001 and is the answer not in the manual?

Questions and answers

Summary of Contents for PowerDsine 6001

  • Page 1 P/N Y1-6040-010 Rev. A0 1-Port Power over LAN User Guide Notice It is PowerDsine’s policy to improve its products as new technology, components, software, and firmware become available. PowerDsine, therefore, reserves the right to change specifications without prior notice. Trademarks The product described in this guide is a licensed product of PowerDsine.
  • Page 2 The device is design to meet the IEEE802.3af standard The Power over LAN Hub adds 48VDC to the unused (non-data) wires in standard Category 5 Ethernet cable. As a result, the Power over LAN Hub delivers both data and power to the terminal.

Table of Contents