WAGNER CLICK&PAINT W 687 E Operating Instructions Manual page 27

W 687 E
Preparation of the workplace (for interior wall paint)
Cover all surfaces and objects that should not be sprayed, or remove
them from the work area.
Silicate paint corrodes glass and ceramic surfaces upon contact! All
such surfaces must therefore be completely covered.
Pay attention to the quality of the adhesive tape used.
i
Do not use excessively strong adhesive tape on wallpaper and painted
surfaces, in order to avoid damaging these surfaces when removing the
tape. Remove adhesive tape slowly and evenly; do not use jerky movements.
Do not leave adhesive tape on surfaces any longer than necessary, in order
to minimise the possibility of residues when removing.
Also observe the adhesive tape manufacturer's instructions.
Preparation of the Coating Material
a) For low-viscosity coating substances
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer ( Internet download).
1. Stir the material up and put the required amount into the paint container.
Sprayed material
Glazes
Wood preservatives, mordants, oils,
disinfection agents, plant protective agents
Paints containing solvents and water-soluble
paints, primers, vehicle coating paints,
thick-film glazes
Wall paints with the red Perfect Spray logo
2. If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements.
Thinning recommendation
undiluted
undiluted
dilute by 5 - 10%
Dilute in accordance with
manufacturer's instructions
GB
21