Carburetor Controls; Pressurized Fuel System - O.S. engine MAX-15CV-R Series Owner's Instruction Manual

BATTERY INTEGRATED GLOWPLUG HEATER
Commercialy available
glowplug heater in which the
glowplug battery and battery
leads are integrated.
FUEL PUMP
For filling the fuel tank, a simple,
polyethylene "squeeze" bottle,
with a suitable spout, is required.
LONG SOCKET WRENCH
Recommended for easy removal
and replacement of the angled
and recessed glowplug, the
O.S.Long Socket Wrench
incorporates a special grip.
SILICONE FUEL LINE
Heatproof silicone tubing of
approx. 5mm o.d. and 2mm i.d.
is required for the connection
between the fuel tank and
engine.
CARBURETOR CONTROLS ( 10E-R )
Three adjustable controls are provided on this
carburetor.
The Needle-Valve:
For adjusting the mixture strength when the throttle
is fully open.
The Mixture Control Screw:
For adjusting the mixture strength at part-
throttle and idling speeds, to obtain steady
idling and smooth acceleration to mid speeds.
The Throttle Stop Screw:
For setting the minimum idling speed:
NOTE:
Readjustment may
be necessary, occa-
sionally to allow for
changes in fuel, gear
ratio or clutch en-
Throttle
gagement point.
Stop Screw
Mixture Control Valve
Assembly Screw
CARBURETOR CONTROLS ( 10C )
handy
Three adjustable controls are provided on this
carburetor.
NOTE:
Readjustment
be necessary, occa-
sionally to allow for
changes in fuel for-
mula, gear ratio or
clutch engagement
point.
14
Needle Valve
15
The Needle-Valve:
For adjusting the mixture strength when the throttle
is fully open.
The Mixture Control Screw:
For adjusting the mixture strength at part-
throttle and idling speeds, to obtain steady
idling and smooth acceleration to mid speeds.
The Throttle Stop Screw:
For setting the minimum idling speed.
Ball Link
may
Throttle Stop Screw

PRESSURIZED FUEL SYSTEM

The somewhat violent changes of vehicle attitude
that occur in off-road running, combined with the
fact that, in buggy type cars, the fuel tank is often
located some distance from the carburettor, means
that fuel 'head' at the carburettor can vary and upset
running.Therefore,it is recommended that a muffler
pressurized fuel feed system be used.
Never run your vehicle without installing the air
cleaner. Dust and dirt that may otherwise be drawn
into the engine will rapidly shorten its life.
Connect suitable length of
Fuel Tank Silicone tubing between fuel
tank and silencer.
Needle Valve
Mixture Control Valve
Assembly Screw
Silicone tubing
Silencer