Panasonic Omnivision PV-1540 Operating Instructions Manual page 15

IfGfr {!I'TPUT G}IAHilM
$TLECTIIIffiCilEMEN. RSGEP?I{'fr
SHEGK
PV.154O
Once you have connected the VCR to the TV
(pg.
12, 13, 17,18 or
19), you are
ready
to
set the predetermined
output channel
(cH3 or
4) on which the VCR
will
send its signal to your
TV
set.
1.
Turn on VCR and
TV.
2'
Check TV
reception in your area on channel
3
or
4.
Pick the weakest channel as your
,,predetermined',
channel.
3'
Push the VCR/TV Selector Button located on the front of VCR,
"VCR"
will be indicated on the Multi
Function
Display.
4.
On
back of VCR, set
CH 3/4 switch to your predetermined
channel.
5.
Set your TV channel selector
to the predetermined VHF channel (3 or
4) you
set in
step
4.
CHANNEL RECEPTION CHECK
Set the
VCR/TV Selector located on the front of the VCR,
"VCR" will be
indicated on
the
Multi Function
Display.
select a
channel on the VCR that you would norrnally receive clearly in your
area.
o
lf the reception
of all
VHF channels
is unsatisfactory, you
,"y
need to tune your
TV
set.
HOW TO TUNE YOUR TV SET TO CHANNEL 3
or
4
Locate the
AFT
(Automatic Fine Tuning) switch on the
TV,
and set it
in the OFF position.
Adjust the TV
Fine Tuning at the
middle range position which gives
the
best picture.
Reset the AFT switch to
the
oN
position.
The picture should remain
clear.
1.
2.
1)
2)
3)
Rear
View of
VCR
ON,CH3or4
NoTE:SomeTVsetshaveelectronictunerswhichaUtomaticalIyfinetune;"m
this type of tuner,
it
probably does not provide any manual a;ilil;.
-14-