Download Print this page

Installation Instruction - j&a EMPRESS GT User Manual

Advertisement

Installation Instruction

1.
Make a hole ( size 1-3/8") for the On/Off switch as shown (see fig 1)
pre-drilled
2.
Placed a 1/8" clear hose into the rear of the switch and on/off switch
into the hole.
3.
The discharge pump kit is made to fit onto the pedicure unit. (see fig 2)
4.
Connect E-Z connector onto the drain elbow.
5.
Plug discharge pump outlet into the two minute timer outlet
6.
Plug two minute timer into the wall outlet.
7.
It is very important that tip of the clear tub remain above the water
level
** Please cut to fit Flex hose to size**
Air Check Valve
Clear Tubing 3/4 OD ½"ID
Rubber Gasket
Poly Insert 90 Elb ½"
Elbow
(LARGE Rubber Coupling)
3/4" PVC Pipe
Operation Instruction
Warning ! DO NOT RUN DRY
1.
Turn to open drain plug. 3 to 5 second for air to release from the pipe
2.
Press On/Off switch to activate timer.
3.
At any time, water drain completely from the basin. Press
On/Off switch to stop built in two minute timer.
Empress GT: Discharge Pump (Optional)
Up to3 ft +/- 45 sec. with 3/4" outlet
(SMALL Rubber Coupling)
3/4" Elbow
TEE 3/4 X 3/4 X ½"
Pump
LARGE Rubber Coupling
3/4" Discharge Pipe Outlet
Drain outlet MUST be 3/4"
pipe for efficient drainage
3/4" x 3/4" Brass
swing check valve Required
Note:
3/4 PVC Pipe
3/4" PVC Pipe
Model: TS-B40-3A
Rating: 120VAC. 60Hz. 0.8A. 75W
Flow Rating: 6 Gal. Per Min.
Max. Lift: 3 FT.
Electrical Control Box
1/8" clear Tube
from On/Off Switch
for Part time control box
Power Plug
to wall outlet
Pipeless Motor
Power Plug
FULL TIME
2 Min.Timer
(D.pump)
3/8" Clear Tube from on/off for D/P pump
insert into 2 Min. Timer.
Make sure to push in tightly.

Advertisement

loading