Table of Contents
Advertisement
Fault
and programme
terminated.
Condensation in the
condensation tank
even though the water
drain hose is connec-
ted.
The programme does
not start.
The length of the pro-
gramme changes dur-
ing the drying cycle.
Pumping noise.
Buzzing noise.
The drying time is too
long.
Cause and troubleshooting
Rinse the water drain hose with tap water.
▶
The filter for the condensation tank is soiled.
→ "Clean the filter for the condensation tank.",
▶
Page 49.
Foreign object is located in the base unit
→ "Opening the base unit", Page 47.
1.
Remove the foreign objects that are present.
2.
→ "Closing the base unit", Page 48.
3.
Dirt in the appliance.
Preparing the appliance for the intensive appliance
▶
care programme.
→ "Preparing the appliance for the intensive appli-
ance care programme", Page 43.
The appliance uses condensation for the automatic
self-cleaning.
Not a fault – no action required.
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
Childproof lock is activated.
→ "Deactivating the childproof lock", Page 34
▶
You have not pressed
Press
.
▶
No programme set.
→ "Setting a programme", Page 30.
1.
→ "Starting the programme", Page 30.
2.
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
Condensation pump active.
Not a fault – normal operating noise.
▶
Compressor ventilation active.
Not a fault – normal operating noise.
▶
Fluff filter is soiled.
→ "Cleaning the fluff filter", Page 31
▶
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is lower than
▶
30 °C.
Troubleshooting en
.
53
Advertisement
Table of Contents
