Set Up An Ipv6 Internet Connection - TP-Link Archer A6 User Manual

Chapter 4
Note:
It may take 1-2 minutes to make the settings valid.
Tips:
• If your internet connection type is
• If you use Dynamic IP and
please go to Advanced >
• If you still cannot access the internet, refer to the
4. 3.

Set Up an IPv6 Internet Connection

Your ISP provides information about one of the following IPv6 internet connection types:
PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge).
1. Visit http://tplinkwifi.net, and log in your TP-Link ID or with the password you set for
the router.
2. Go to Advanced > IPv6.
3. Enable IPv6 and select the internet connection type provided by your ISP.
Tips:
If you do not know what your internet connection type is, contact your ISP or judge according to the already known
information provided by your ISP.
4. Fill in information as required by different connection types. Red blanks must be filled
in.
1 ) Static IP: Fill in blanks and click Save.
BigPond Cable, please go to
PPPoE and you are provided with any other parameters that are not required on the page,
Network > Internet to complete the configuration.
FAQ
Advanced > Network
section for further instructions.
Set Up Internet Connection
> Internet to set your router.
18