Sending And Receiving Commands - Polycom EF2201 Application Note

• For an EF2280 and EF2241, we recommend the following PASSTHRU
command:
PASSTHRU COM x baud rate
where x is the com port of the Crestron control system and baud rate is
any data rate of 9600, 19200, or 38400 bps.
You don't have to type these settings in Viewport. You can click on
F , E
UNCTIONS NTER
value that was described above. However, in our testing with a
CP2, we received an Invalid Parameters response from the CP2
when we tried to execute that feature.
Sending and Receiving
Commands
Once you've sent the proper PASSTHRU command, click Setup and make sure
that L E is checked and D
OCAL CHO
(O ) is optional.
UTGOING
P M
ASSTHROUGH ODE
H
ISPLAY IN
(CNX/2 S ) and set every
ERIES
M is unchecked. CR
EX ODE
CR/LF
TO