Troubleshooting; My Device Will Not Connect To The Sensors; Limited Warranty - Garmin SPEED SENSOR 2 Owner's Manual

Hide thumbs Also See for SPEED SENSOR 2:

Table of Contents

If your device will not connect to the speed and cadence sensors, you can try these tips.

• Rotate the crank arm or wheel two revolutions to wake up the sensor.

The LED flashes green for five seconds to indicate activity. The LED flashes red to indicate a low battery

level.

• Replace the battery if the LED does not flash after two revolutions.

• Enable Bluetooth technology on your smartphone or Garmin device.

• Pair the sensor with your device using ANT+ technology.

NOTE: If the sensor is already paired with two Bluetooth devices, you should pair using ANT+ technology or

remove a Bluetooth device.

• Remove the sensor from your Garmin device to retry the pairing process.

• Remove the speed sensor from the Garmin Connect app and the Bluetooth settings on your smartphone to

retry the pairing process.

The Garmin standard limited warranty applies to this accessory. For more information, go to

/support/warranty.

Troubleshooting

www.garmin.com

Table of Contents

Do you have a question about the SPEED SENSOR 2 and is the answer not in the manual?

Cadence sensor 2