Program - VALBERG 14S40 B XAD929C Instructions For Use Manual

C C
Useful information Useful information
Problem Possible causes
Wrong detergent.
Foam in the tub
Spilled rinse aid.
Detergent with colourant
Stained tub interior
may have been used.
White film on inside surface Hard water minerals.
The affected items are not
corrosion resistant.
A program was not run after
There are rust stains on
dishwasher salt was added.
cutlery
Traces of salt have gotten
into the wash cycle.
The lid of the softer is loose.
52
What to do
• Use only the special
dishwasher detergent to
avoid suds. If this occurs,
open the dishwasher and let
suds evaporate. Add 1 liter
of cold water to the bottom
of the dishwasher.
• Close the dishwasher
door, then select any cycle.
Initially, the dishwasher will
drain out the water. Open
the door after draining
stage is complete and
check if the suds have
disappeared.
• Repeat if necessary.
• Always wipe up rinse aid
spills immediately.
• Make sure that the
detergent has no colourant.
• To clean the interior, use
the damp soft cloth with
dishwasher detergent and
wear rubber gloves. Never
use any other cleaner than
dishwasher detergent for
the risk of foaming or suds.
• Avoid washing items that
are not corrosion resistant
in the dishwasher.
• Always run a wash
program without any
crockery after adding salt.
Do not select the Turbo
function (if present), after
adding dishwasher salt.
• Check the softener lid is
secure.
EN
C C
Useful information Useful information
Problem Possible causes
Knocking noise in the A spray arm is knocking
dishwasher against an item in a basket
Rattling noise in the Items of crockery are loose
dishwasher in the dishwasher.
This may be caused by
Knocking noise in the water
on-site installation or the
pipes
cross-section of the piping.
The dishes were not loaded
correctly.
The program was not
powerful enough.
Not enough detergent was
dispensed.
Items are blocking the
The dishes are not clean
movement of the spray
arms.
The filter combination is
not clean or is not correctly
fitted in the base of wash
cabinet. This may cause
the spray arm jets to get
blocked.
Combination of soft water
Cloudiness on glassware.
and too much detergent.
White spots appear on Hard water area can cause
dishes and glasses. limescale deposits.
Black or grey marks on Aluminium utensils have
dishes rubbed against dishes
53
What to do
• Interrupt the program and
rearrange the items which
are obstructing the spray
arm.
• Interrupt the program,
and rearrange the items of
crockery.
• This has no influence on
the dishwasher function. If
in doubt, contact a qualified
plumber.
• See "Preparing And
Loading Dishes".
• Select a more intensive

program.

• Use more detergent, or
change your detergent.
• Rearrange the items so
that the spray can rotate
freely.
• Clean and/or fit the filter
correctly. Clean the spray
arm jets.
• Use less detergent if you
have soft water and select
a shorter cycle to wash the
glassware and to get them
clean.
• Check water softener
settings or fill status of salt
container.
• Use a mild abrasive
cleaner to eliminate those
marks.
EN