Daikin FTXM18PVMK Operation Manual page 107

„ Titanium apatite photocatalytic air-purifying fi lter
1.
Open the front panel and
pull out the air fi lters.
2.
Take off the titanium apatite
photocatalytic air-purifying
fi lters.
• Hold the recessed parts of the frame and unhook
the 4 claws.
Claw Claw
3.
Clean or replace the
titanium apatite
photocatalytic air-purifying
fi lters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15 minutes if very dirty.
• Do not remove the fi lter from the frame when
washing with water.
3-2 After washing, shake off remaining
water and let them dry in the shade.
• Do not wring out the fi lter to remove water from it.
[Replacement]
Remove the fi lter from the fi lter
Page 28,29
frame and attach a new one.
• Do not throw away the fi lter frame. Reuse the fi lter
frame when replacing the titanium apatite
photocatalytic air-purifying fi lter.
• When attaching the fi lter, check that the fi lter is
properly set in the tabs.
• Dispose of the old fi lter as non-fl ammable waste.
4.
Set the titanium apatite
photocatalytic air-purifying
fi lters as they were.
5.
Set the air fi lters as they
were.
6.
Close the front panel slowly.
NOTE
• Operation with dirty fi lters:
− cannot deodorise the air,
− cannot clean the air,
− results in poor heating or cooling,
− may cause odour.
• Dispose of old fi lters as non-fl ammable waste.
• To order a titanium apatite photocatalytic air-purifying fi lter, contact
the dealer where you bought the air conditioner.
Item
Part No.
Titanium apatite photocatalytic
air-purifying fi lter (without frame) 1 set
KAF970A48
Care
Page 29
Page 28
30