Table of Contents
Advertisement
Installation
Cold water con-
nection
Using the ma-
chine in cold wa-
ter mode
Hot water con-
nection
Using the ma-
chine in hot water
mode
62
For the cold water connection one stopcock each with a ¾" screw
thread is required.
If a water connection is not available, only a qualified installer may
connect the washing machine to the mains water supply.
The water inlet hose for cold water is not suitable for connection to
a hot water supply.
In the event that hot water is not available on site, a cold water supply
must be used for the hot water connection.
The required amount of hot water should be added to the cold water
volume.
Alternatively, the hot water connection should be blocked using the
blind stopper supplied with the machine and the machine controls
should be set to cold water intake by the service technician.
For cold water mode, a cold water connection must be established at
the cold and hot water valve.
Alternatively, the hot water valve can be deactivated by the techni-
cian. The following steps must be performed.
The service technician must deactivate the hot water valve.
Unscrew the hot water hose.
Screw on a stopper.
The same connection requirements as for cold water also apply to
hot water up to 70 °C.
A suitable connection hose with a threaded union is supplied with the
machine.
The machine with hot water connection also requires a cold water
connection.
For hot water mode, connect the hot water and cold water connec-
tions to the relevant valves. Both connections are required.
Advertisement
Table of Contents
