Attaching The Blade - Bosch CCS180-B15 Operating/Safety Instructions Manual

Disconnect battery pack from tool before making any assembly, adjustments or
changing accessories. Such preventive safety measures reduce the risk of starting the tool
accidentally.
▶ Inserting and Releasing Battery Pack
recommended in the battery/charger list,
included with your tool. Using other types of
batteries may result in personal injury or property
damage.
Slide charged battery pack into the housing until the
battery pack locks into position (Fig. 1).
Your tool is equipped with a secondary locking latch
to prevent the battery pack from completely falling
out of the handle, should it become loose due to
vibration.
To remove the battery pack, press the battery pack
release button and slide the battery pack forward.
Press the battery pack release button again and
slide the battery pack completely out of tool housing
(Fig. 1).
UPPER
GUARD
LOWER GUARD
BLADE SHAFT
LOWER GUARD SPRING
INNER WASHER
Large Diameter Faces Blade
Assembly
U s e o n l y B o s c h o r
A M P S h a r e b a t t e r i e s
Fig. 2

▶ Attaching the Blade

min (RPM) or greater. Using blade not designed
for the saw may result in serious personal injury and
property damage.
1. Turn BLADE STUD with wrench provided
clockwise and remove BLADE STUD and OUTER
WASHER (Fig. 2). If the shaft moves while
attempting to loosen the blade stud press the
lock button (Fig. 1).
2. Make sure the saw teeth and arrow on the blade
point in the same direction as the arrow on the
lower guard.
3. Retract the lower guard all the way up into the
upper guard. While retracting the lower guard,
check operation and condition of the LOWER
GUARD SPRING.
4. Slide blade through slot in the foot and mount it
against the INNER WASHER on the shaft. Be sure
the large diameter of the OUTER washer lays
flush against the blade.
WRENCH
BLADE
-10-
Use only 6-1/2" blade. Use
only blade rated 3900/
MARK
OUTER
WASHER
OUTER WASHER
Large Diameter
Faces Blade
BLADE STUD
TIGHTEN
LOOSEN