Indoor Unit Installation Drawings - Daikin FTX25J2V1B Installation Manual

Indoor Unit Installation Drawings

Mounting plate
Screws
(Field supply: M4 × 25L)
Front panel
50mm or more from walls
(on both sides)
Titanium Apatite Photocatalytic
Air-Purifying Filter (2)
Titanium Apatite
Photocatalytic
Air-Purifying Filter
Filter frame
Tab
4
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
30mm or more from ceiling
Air filters
M4 × 16L
Air filter
How to attach the indoor unit.
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit.
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
release, remove the front grille.
Service lid
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screws.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
Screws
(Field supply: M3 × 20L)
Bottom frame
Front grille
Cut thermal insulation
pipe to an appropriate
Caulk
length and wrap it with
pipe hole
tape, making sure that no
gap
gap is left in the insulation
with putty.
pipe's cut line.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Before screwing the remote
controller holder to the wall,
Wireless
make sure that control
remote
signals are properly
controller
received by indoor unit.
Remote
controller holder
Mounting
plate
Clip
Mark (rear side)
English