Leds - D-Link DSL-245GE User Manual

Section 1 - Product Overview
1 Power
2 DSL
3 Internet
4 WAN/LAN
5 Ethernet
Wireless
6
2.4G/5G
7 WPS
D-Link DSL-245GE User Manual
Hardware Overview
1
Lights up green when the router is powered on and operating normally. When the router
Solid green
boots up or reboots, the LED lights up red. It also lights up red during the factory reset
Solid red
process. It flashes red when an error occurs or during firmware upgrade (when the Internet
Blinking red
LED also flashes).
Solid green
Lights up green when the DSL connection is established through the DSL port. Flashes
Blinking green
green when the port is negotiating a connection. Off indicates these is no DSL connection.
Off
Solid green
Lights up green when there is an Internet connection. Flashes green when there is Internet
Blinking green
activity. It is red when an Internet connection failure occurs (due to authentication failure, IP
Solid red
assignment failure, etc.). It flashes red when firmware upgrade is in progress. Off indicates
Blinking red
there is no broadband connection available.
Off
Solid green Lights up green when the Ethernet WAN port has established a successful connection. It
Blinking green flashes green when there is activity on this port. It is off when a connection failure occurs
Off or the port is not connected.
Solid green
Lights up green when the respective LAN port is connected. It flashes green when there is
Blinking green
activity on this LAN port. Off indicates the LAN port is not connected.
Off
Solid green
Lights up green when the 2.4 or 5 GHz wireless network is enabled. Flashes green when
Blinking green
there is wireless activity.
Off
Solid green
Lights up green when a Wi-Fi Protected Setup is established successfully. Flashes green
Blinking green
when the WPS process is active. Off indicates that WPS is idle.
Off

LEDs

2 3 4 6 7 8
5
Off indicates wireless function is disabled.
7