2 ] Error Codes Shown In The "Machine Error Xx" Message - Brother FAX218 Service Manual

[ 2 ] Error codes shown in the "MACHINE ERROR XX" message
Error Code
xx
(Hex.)
( 87
( 89
8A
( 8B
( A1
( A2
( A3
( A4
( A5
( A6
( A7
( A8
( A9
( AB
( AC
( B9
( BE
( BF
( D5
( D6
( E4
E6
( E8
F3
( F5
( F6
( F7
Error codes in parentheses do not appear in the "MACHINE ERROR XX", since those errors are displayed as
messages described in "[ 1 ] Error messages on the LCD." You can display those error codes in the mainte-
nance mode (Function code 82). Those error codes appear in the communications error list if an equipment
error occurs during communications. Refer to Section 1.2, (13).
* Those codes marked with an asterisk can appear only in the maintenance mode.
Fails to complete the sequence of recording operation. )
Cutter jam. )
Wrong or weak contact of the recording head connectors.
Recording head overheat. )
Recording paper cover opened. )
Document too long to scan. )
Document not detected by the document rear sensor. )
50% or more faulty of white level data. ) *
Faulty operation of DMA0 during scanning. )
Faulty operation of DMA1 during scanning. )
One-line feeding time-out error. )
One-line scanning time-out error. )
Abnormal scanning reference voltage. )
Document feed-in amount measuring error. ) *
Less than 50% faulty of white level data. ) *
Light emission intensity error of the LED array. )
Abnormal clamp PWM value )
Light emission intensity error of the LED array at the setting time of initial
values. ) *
The MODEM fails to complete the command transmission sequence. )
No MODEM interrupt for 60 seconds. )
Out of recording paper. )
2
Write error in E PROM.
Data scanning error during transmission. )
Voice message recording or playing-back not started.
EOL not found in page memory transmission mode. )
PC interface error. )
Optional handy scanner interface error. )
VI – 3
Error factor