Table of Contents
Advertisement
ü If you are connected to a DHCP Server or Router,
select 'Obtain an IP address automatically'. You will be
given an automatic IP Address and Subnet Mask.
6) Set the network configurations of MEDIAGATE T1.
ü You must connect MEDIAGATE T1 to a TV set for this
setup. See "3.1.1 Connect Video Cable".
Press [SETUP] on MEDIAGATE T1 remote control to
display the Setup screen. Select 'DHCP: Off' and
enter the IP address & Subnet mask.
For example, you may enter:
IP Address: 192.168.000.002
Subnet mask: 255.255.255.0
After entering IP and Subnet, press [SETUP] again to
save the configurations.
ü If you are connected to a DHCP Server or Router,
select 'DHCP: ON'. You will be given an automatic IP
Address and Subnet Mask from the DHCP Server or
Router. You can then see the IP Address/Subnet Mask
that was issued.
ü The IP Address of the MEDIAGATE T1 MUST be on
the same range as the computer or network.
example, if MEDIAGATE T1 is at 192.168.0.2 and the
computer is on 192.168.1.3, then they will not be able to
communicate. The first three sets of numbers must
match, while the fourth set of number(s) must be unique.
The Subnet Mask must always match.
<MEDIAGATE T1's IP Address>
46
For
Advertisement
Table of Contents
