Plextor ConvertX PX-AV100U Installation And User Manual page 35

Section 3. Using the ConvertX with WinDVD Creator
In the Device Control tab, select the Video Source (S-Video or
Composite) you have connected to the ConvertX. You can also
select the Video Standard; set this to match the type of video
that is coming into the ConvertX. (In general, NTSC is the TV
standard used in North America and Japan, while PAL is used in
Europe and South America. SECAM is used in France, Eastern
Europe, and some African nations.)
Use the Video Qualities tab to change the characteristics of the
video you capture. (To begin, you can leave these characteristics
set at their default values, and change them if your video is
consistently too dark, too light, has too much contrast, etc.)
4. Press the Record button
panel. The indicator on the button turns into a white square and the
on-screen indicator blinks. You see the video in the preview
window. In the disk information area you can see the free and used
areas of your hard disk changing as video is recorded.
IMPORTANT: If you don't seem to be getting any video in the preview
window, make sure you have used the Device Control tab to select the
same Video Source (S-Video or composite) that matches the physical
connection to the ConvertX.
CAUTION: Do not attempt to launch other applications while capturing.
Video data may be corrupted if CPU usage approaches 100 percent.
5. When you have obtained the desired video, stop the recording by
pressing the Record button
your video file in the media library (for video, this is the video
library) located in the bottom-right section of the Capture window.
Plextor ConvertX PX-AV100U Installation and Users Manual
on WinDVD Creator's on-screen control
again. Recording stops, and you see
29