Troubleshoot Other Devices; Changing To Another Computer; Connect Video And Audio To Your Convertx - Plextor ConvertX PX-AV100U Installation And User Manual

Section 2. Installing Your ConvertX

Troubleshoot Other Devices

• In the Device Manager, if any of your entries for Other devices have
a yellow diamond with an exclamation point (!), troubleshoot your
Plextor ConvertX device for compatibility problems or other
conflicts. It may just be a matter of obtaining the latest USB driver,
or the Windows 2000 or Windows XP Service Pack from
Microsoft's Windows Update.
• To update the PX-AV100U driver, right-click on the question mark
and select Properties, then select the Driver tab and click Update
driver. Look for the device driver on the Plextor CD.

Changing to Another Computer

Before using your ConvertX on a different computer, use the ConvertX
installation CD and install the ConvertX drivers on that computer.

Connect Video and Audio to Your ConvertX

To connect the ConvertX video and audio input:
• Connect your analog video source to the ConvertX front-panel input
connectors. Figure 9 shows some of the sources you can use.
To use composite video: Plug one end of the supplied yellow
RCA cable to the Line Out or Video Out connector on your
video source; and connect the other end to the yellow Video
input connector on the ConvertX front panel.
To use S-Video: To get higher quality video, plug one end of an
S-video cable into the S-Video output connector on your video
source; and plug the other end into the black S-Video input
connector on the ConvertX front panel. (The S-video cable is
not supplied by Plextor.)
NOTE: Some video devices do not have S-Video output connections.
In this case, use the yellow RCA cable and connections (as for
composite video above).
18
Plextor ConvertX PX-AV100U Installation and Users Manual