Damage Resulting From Poor Installation Or Misuse; Fans Broken By Use Of Compressed Air For Cleaning; Devices Subject To Water Or Liquid Ingress - System Sensor FAAST LT-200 Setup And Troubleshooting Manual

Hide thumbs Also See for FAAST LT-200:

Table of Contents

● Loosen or remove the screws (Figure 8: red arrows) fixing the

cover of the main PCB. This could damage the PCB or the

electronic components mounted on it, and compromise the

sealing protection of the gasket. Do no remove the PCB from

the main box for any reason.

Figure 8: Main PCB cover

ALL THE ACTIONS DESCRIBED ABOVE

WILL INVALIDATE THE WARRANTY .

DAMAGE RESULTING FROM POOR INSTALLATION OR MISUSE

Here are some pictorial examples of what can happen when advice

in this guide is ignored.

Examples of fans broken by the use of compressed air

for cleaning

This unit was used in a dirty environment without an external filter

being added to the pipe network. Then cleaning was attempted

with compressed air:

Examples of devices subjected to water or liquid ingress

Fluid ingress marks or attacks the internal parts of the unit:

I56-6304-000

Table of Contents

Do you have a question about the FAAST LT-200 and is the answer not in the manual?