Procedure For Tilting Up (Power Tilt Models) - Yamaha FT8D Owner's Manual

Do not use the tilt support lever or
knob when trailering the boat. The out-
board motor could shake loose from
the tilt support and fall. If the motor
cannot be trailered in the normal run-
ning position, use an additional sup-
port device to secure it in the tilt
position. For more detailed informa-
tion, see page 54.
EMU32724
Procedure for tilting up (power tilt
models)
1. Place the remote control lever in neutral.
N
2. Press the power tilt switch "
the outboard motor has tilted up com-
pletely.
[ECM01641]
ZMU03196
" (up) until
3. Push the tilt support knob into the clamp
bracket to
WARNING! After tilting the outboard
motor, be sure to support it with the tilt
support knob or tilt support lever. Oth-
erwise the outboard motor could fall
back down suddenly if oil in the power
trim and tilt unit or in the power tilt unit
loses pressure.
not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the motor cannot
be trailered in the normal running po-
sition, use an additional support de-
vice to secure it in the tilt position. For
more detailed information, see page
54.
[ECM01641]
4. Models equipped with trim rods: Once the
outboard motor is supported with the tilt
support lever, press the power trim and
Operation
support the engine.
NOTICE: Do
[EWM00262]
49