Installation - Daitsu ADP 12AM Instruction Manual

07ManPORTATILDaitsuEng 7/2/07
(1) Important
Install the mobile ir conditioner in a flat and spacious location where the air
outlets will not be covered up. A minimum clearance of 30cm from a wall or
other obstacles should be kept. The appliance shall not be used in the laundry.
The plug shall accessible after appliance is positioned.
Wiring shall be done according to National rules.
(2) Duct mount instructions
Temporary
1-
Attach one end of the duct to the exhaust air outlet of the mobile air condition,
first fit the left side of the duct on the exhaust air panel, then the right side duct.
Push it downwards, be sure to fix thoroughly. (See the figures)
2-
Attach the other end of the duct to adaptor B.
3-
Put the end of duct to a nearby window.
Permanent
1-
Attach one end of the duct to the exhaust air outlet of the mobile air conditio-
ner. According to the arrow direction, first fit the left side of the duct on the
exhaust air panel, then the right side duct. Push it downwards, be sure to fix
thoroughly. (See the figures)
2-
Install the adaptor A onto the wall by using 4 wall plug and screws, be sure to
fix thoroughly. (See the figures)
3-
Attach the other end of the duct to adaptor A.
4-
Cover the hole using the adaptor cap when not in use.
• The duct can be compressed or extended between 500mm and 2000mm, but
it is desirable to keep the duct length to a minimum.
10:13 Página 37

INSTALLATION

30 cm
30 cm
Exhaust Air Oulet
Duck
Adaptor A
Screws
Wall plug
max. 120cm
min. 30cm
IMPORTANT
Do not over bend the duct (see figure)
37