Plantronics M3000 Pairing Instructions page 15

M3000 Pairing Instructions – Sony Ericsson P800 Mobile Phone
Before pairing the Plantronics M3000 with the Sony Ericsson P800, please
ensure both devices are fully charged according to the instructions in the
respective User Guides.
1. Turn the Sony Ericsson P800 phone and the Plantronics M3000 headset ON.
2. On the P800, open the flip and using the Jog Dial (rotate and press) and
stylus:
i. Scroll to "Control Panel" and press the jog dial.
ii. Select "Connections" using the stylus
iii. Scroll down to "Bluetooth" and press the jog dial
iv. Select "Settings" using the stylus
v. Using the stylus, change the "Operation Mode" to "On"
vi. Using the stylus, select "Done"
Bluetooth is now be switched on in the phone.
Note: If Bluetooth has already been activated, press "Done" anyway.
3. On the Plantronics M3000:
i. Put the M3000 into pairing mode by press the "Volume Up" &
"Call Control" buttons simultaneously until the Indicator light
begins to flash alternate green and red. (see M3000 User
Instructions).
4. On the Sony Ericsson P800:
i. Scroll down to "Bluetooth" and press the jog dial.
ii. Using the stylus, select "Devices"
iii. Using the stylus, select "Add"
iv. The phone will display "Searching".
v. After a few moments the phone will display all the Bluetooth
devices within range. Using the stylus, select the "M3000 by
Plantronics".
vi. The phone will display "Bonding in Progress"
vii. The phone will request the "Passkey:". Enter 0000 using the
keypad then press the jog dial. The phone will display
"Bonding in Progress" followed by "Bonding Successful".
viii. Using the stylus, select "Done"
Your M3000 headset is now paired with the P800 phone.
P800 M3000 pair rev001
Plantronics Ltd - Released
1
rd
3 July 2003