72 | Installing the Md5/PCX Board and Driver in a Sun PCI Workstation
Before You Begin
If you are using an Md5/PCX board with a part number that
predates 55-MD5PCX1-3x or 55-MD5PCX2-3x, you must disable
PCI bus parity on the Sun PCI workstation before you install the
Md5/PCX board and driver.
To determine the part number and revision of your
Md5/PCX board, check the sticker with the CE mark on
the video connector.
Part numbers that predate 55-MD5PCX1-3x
or 55-MD5PCX2-3x
If you are using an Md5/PCX board with a part number that
predates 55-MD5PCX1-3x or 55-MD5PCX2-3x, follow these steps:
1.
Disable parity as described in "Disabling Parity on a Sun
Ultra System" on page 73.
2.
Install the board as described in"To install the board" on
page 78.
3.
Install the driver as described in "Installing the Solaris
Driver" on page 86.