Radio Shack 63-251 - Travel Alarm Clock Manual

Also See for 63-251:

User manual (1 page)

Table of Contents

Contents

1 Check package contents
2 Features
3 Overview
4 Set the Clock
5 Set the Alarm
6 Switching Off the Alarm
7 Resetting the Clock
8 Replacing the Battery
9 Battery Notes
10 Care and Use
11 Specifications
12 Documents / Resources
- 12.1 Download manual

Radio Shack 63-251 - Travel Alarm Clock Manual

Check package contents

Travel alarm clock (with battery installed)
User's guide
Quick start

Features

Small, portable design
Snooze function
Indoor temperature display

Note:
Remove the plastic tab in the battery compartment before using.

Overview

Notes:

In 12 hour format, an "AM" or "PM" sign will appear to indicate morning or evening hours.
Temperature appears after a few seconds when you power on the alarm clock.

Set the Clock

Hold down SET Date. The digits of month, date and year flash.
Continue holding SET Date and press HOUR/ Month, MIN/Date, or 12/24/Year to change the month, date, and year.
Release SET Date to confirm.
Hold down SET Time. The hour and minute digits flash.
Continue holding SET Time and press HOUR/ Month, MIN/Date, or 12/24/Year to select the time and hour format.
Release SET Time to confirm

Set the Alarm

Hold down SET Alarm. The hour and minute digits flash.
Continue holding down SET Alarm and press HOUR/MONTH, MIN/DATE, 12/24 Year to select the time and hour format.
Release SET Alarm to confirm.

Switching Off the Alarm

There are three ways to switch off the alarm.

Repeat Alarm: SNOOZE

Slide ALARM switch to SNOOZE. and appear on the display. When the alarm sounds, press SNOOZE to stop for 5 minutes. Press it when the alarm goes off again to delay for 5 more minutes.

Note:
If you don't press SNOOZE, the alarm will sound for 1 minute, then stop to enter the daily alarm reset mode.

24 Hour Alarm Set

Slide ALARM switch to ON, press SNOOZE to turn the alarm off for 24 hours.

Canceling the Alarm Completely

Slide ALARM switch to OFF to switch the alarm off completely.

Resetting the Clock

If the alarm clock malfunctions, use a paper clip to press RESET on the bottom of the clock to the default setting.
Resetting the Clock

Replacing the Battery

Replace the battery when the display dims or sound weakens. To replace, slide the battery compartment tray out. Insert the battery of the same type (3V, CR2032) plus "+" side up.

Slide the tray back into the compartment until it clicks.

The clock and alarm settings cannot be stored and will need to be set again.

Battery Notes

Keep button-cell batteries away from children. Swallowing a button-cell battery can be fatal.
Dispose of batteries promptly and properly. Do not burn or bury them.
Use only fresh batteries of the required size and type.
If you do not plan to use the timer for more than a month, remove the battery. Batteries can leak chemicals that can damage electronic parts.

Care and Use

Keep your alarm clock dry; if it gets wet, wipe it dry immediately. Keep your alarm clock away from dust and dirt. Handle your alarm clock carefully; do not drop it.
Avoid contact with any corrosive materials such as perfume, alcohol, or cleaning agents.
Do not subject the alarm clock to excessive force, shock, dust, temperature or humidity. Any of these conditions may shorten the life of the alarm clock.
Do not tamper with any of the internal components of this alarm clock. This will invalidate the warranty and may cause damage.