Wheels; Body And Deck - Scag Power Equipment SFC-21-5CV Operator's Manual

Section 7
CUTTER BLADE
FLATWASHER
3/8-16 x 3/4" HEX HEAD BOLT
TORQUE TO 39 FT/LBS
Figure 7-6. Blade Replacement
- NOTE -
Be sure that the blade is installed with the lift wing
toward the top.
6. Install the cutter blade onto the the machine. Secure the blades
from rotating and torque to 39 ft/lbs. See Figure 7-6.

7.7 WHEELS

The rear drive wheels should be removed and any debris cleaned
from the wheel gear area after every 40 hours of operation or weekly,
whichever comes first.
1.
2.
FLATWASHER

7.8 BODY AND DECK

1.
2.
3.
31
- NOTE -
In extremely dusty conditions it may be necessary
to clean the wheels more frequently than
recommended to prevent wheel damage and
increase gear life.
To prevent damage to the wheel bearings, do not
use high-pressure water to clean the wheels.
Remove the rear wheels and clean any debris from the wheel
area.
After cleaning the wheels, apply a small amount of anti-seize
lubricant to the gears.
GEAR
Figure 7-7. Rear Wheels
CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
After each use, wash the mower and cutter deck. Use cold
water and automotive cleaners. Do not use pressure cleaners.
Do not spray cold water on the engine, clutch or electrical
components.
Repair damaged metal surfaces using Scag touch-up paint
available from your authorized Scag dealer. Wax the mower for
maximum paint protection.
R