Slope Operation; Parking The Mower; After Operation - Scag Power Equipment SFC-21-5CV Operator's Manual

R
2
1
Figure 4-4. Blade Control Bar Engagement
- NOTE -
A squealing noise may be heard when engaging
or disengaging the deck drive. It is caused by the
clutch plates meshing as the mower comes up to
speed. This is normal. If the noise is excessive,
Contact your local Authorized Scag Power
Equipment Dealer immediately to have the clutch
system repaired..
4. To disengage the cutter blade, release the blade control bar.
The blade control lock lever resets to lock the blade control bar.
5. Always operate the engine at full throttle to properly maintain
cutting speed. If the engine starts to lug down, reduce the
forward speed and allow the engine to operate at maximum
RPM.

4.7 SLOPE OPERATION

WARNING
DO NOT operate on excessively steep slopes.
ALWAYS FOLLOW OSHA APPROVED OPERATION.
Avoid mowing in wet conditions. Wet grass or
leaves can cause serious injury if you slip and
contact the blade.
1. This mower has been designed for good traction and stability
under normal mowing conditions. However, caution must be
used when traveling on slopes, especially when the grass is
wet.
2. To prevent tipping or loss of control, do not start or stop
suddenly, avoid unnecessary turns and travel at reduced speed.
If tires lose traction, disengage the blade and proceed slowly off
the slope.
3. Avoid sudden starts when mowing on slopes.
4. Travel across the slope whenever possible. Never up and down
the slope.

4.8 PARKING THE MOWER

1. Park the machine on a flat, level surface only. Do not park the
machine on an incline.
2. Disengage the cutter blade.
3. Slow the engine to idle speed.
4. Pull the throttle / chock control back to the OFF position.

4.9 AFTER OPERATION

1. Always shut the engine off, wait for all moving parts to stop, and
allow the mower to cool before adjusting, servicing, storing or
cleaning the machine.
2. Wash the entire mower after each use. Do not use high
pressure spray or direct the spray onto components.
- IMPORTANT -
Do not wash a hot or running engine. Cold water
will damage the engine. Use compressed air to
clean the engine if it is hot.
3. Keep the entire mower clean to inhibit serious heat damage to
the engine or transmission.
4. Check the drive belt for proper alignment and any signs of wear.
Correct and adjust if necessary.
DANGER
To avoid injury from burns, allow the mower
to cool before removing the fuel tank cap and
refueling.
5. Fill the fuel tank with fresh, clean fuel at the beginning of every
day of operation. See Engine Owner's Manual for proper octane
requirements.
16
Section 4