Table of Contents
Advertisement
5.4.6 PAIRING OF THE LED CHANNEL WITH THE
TRANSMITTER
l
WARNING: in order to use this function it is necessary to
have correctly performed the procedure described in the
paragraph Setting the independent outputs.
To pair the channel that powers the desired LED strip to the transmitter
("Figure 19"):
1.
press PRG once on the transmitter. The paired LED strip will flash
twice
2.
press
p
or
q
until you select the desired option among those
available in "Table 7".
3.
press
o
for 3 s to confirm the choice and exit the function. The
paired LED strip will flash three times.
19
1
(x 1)
PRG
x 2
3
(3s)
CONFIGURATION WITH A SINGLE OUTPUT (DEFAULT)
Buttons
Channel activated
W1+W2+W3+W4
p
q
OFF
CONFIGURATION WITH TWO INDEPENDENT OUTPUTS
Buttons
Channel activated
W1+W2
W3+W4
p
q
W1+W2+W3+W4
OFF
CONFIGURATION WITH THREE INDEPENDENT OUTPUTS
Buttons
Channel activated
W1
W2
W3
W1+W2
p
q
W1+W3
W2+W3
W1+W2+W3
OFF
10 – ENGLISH
2
( )
End
(x 3)
6
COMMANDS FROM THE TRANSMITTER
6
COMMANDS FROM THE TRANSMITTER
The table shown below summarises the keys to be pressed on the trans-
mitter for sending the main commands to the system.
COMMANDS FROM THE TRANSMITTER (PRESET)
Buttons
p
(x 1)
p
(> 1 s)
o
q
(> 1 s)
q
(x 1)
SLIDER +
SLIDER -
2
COMMANDS FROM THE TRANSMITTER (CUSTOM)
Buttons
p
(x 1)
p
(> 1 s)
o
q
(> 1 s)
q
(x 1)
p
+
q
SLIDER +
SLIDER -
Table 7
Channel activated
Power-on
Increase of the light intensity
Selection of the light intensity
Decrease of the light intensity
Switch-off
Increase of the light intensity
Decrease of the light intensity
Channel activated
Power-on
Increase of the light intensity
Selection of the light intensity
Decrease of the light intensity
Switch-off
Saving of the "custom" intensity (the LED strip will flash
three times to confirm the memorisation)
Increase of the light intensity
Decrease of the light intensity
Table 8
Table 9
Advertisement
Table of Contents
