Table of Contents
Advertisement
3.4
PRODUCT INSTALLATION
To fasten TTDW ("Figure 3"):
1.
position the box (A) and fasten it with bi-adhesive tape (B) (not
supplied)
2.
make the electrical connections by operating as described in the
"ELECTRICAL CONNECTIONS" chapter.
3
B
4
ELECTRICAL CONNECTIONS
4
ELECTRICAL CONNECTIONS
4.1
PRELIMINARY CHECKS
f
All electrical connections must be made with the sys-
tem disconnected from the mains electricity and with the
emergency power supply (if present in the automation)
disconnected.
a
The connection operations must only be carried out by
qualified personnel.
f
Mount a device on the electric power line that completely
disconnects the automation from the grid.
– The disconnection device must have contacts with a sufficient
gap to ensure complete disconnection, under the Category III
overvoltage conditions, in accordance with the installation in-
structions. If necessary, this device guarantees quick and safe
disconnection from the mains power and therefore must be
positioned in sight of the automation. If located in a concealed
position, it must be equipped with a system that prevents inad-
vertent or unauthorised reconnection of power, to avoid poten-
tial hazards.
4 – ENGLISH
4.2
ELECTRICAL CONNECTIONS
To make the electrical connections:
– connect the cable (A) to the chosen 24Vdc power supply unit
– connect the connector (B) to the LED strips.
4
A
OUTPUTS TOWARDS LED STRIPS
PIN
1
2
3
4
5
l
For connecting multiple LED strips, make sure you use
suitable cables and adapters compatible with the con-
nector (B).
5
5
5.1
TWO-WAY AND ONE-WAY OPERATION
The Led Control Range can operate with both TWO-WAY and ONE-
WAY transmission. The transmission mode is determined by the first trans-
mitter (ONE-WAY or TWO-WAY) paired with the system.
l
WARNING: if the system is new (has no transmitter mem-
orised), when it is switched on the paired LED strip will
emit a flash. Run one of the memorisation procedures for
the first transmitter described in the paragraph "Memo-
rising the FIRST TRANSMITTER". If the paired LED strip
does not emit any flash when the system is switched on,
it means that at least one memorised transmitter is al-
ready present.
5
B
A
Exit
W1-W2-W3-W4
OUT 3
White 3 (W3)
OUT 1
White 1 (W1)
OUT 2
White 2 (W2)
Common (+)
OUT 4
White 4 (W4)
PROGRAMMING
PROGRAMMING
OFF
ON
NEW
(x 1)
OFF
1
4
2
3
5
Table 1
BiDi
ERA
ERA
W
P
BD
BD
MONO
ERA
ERA
W
P
Advertisement
Table of Contents
