Advertisement
1
CATCHER SUPPORT ASSEMBLY
1. Remove the side bolts on the engine guard.
2. Using catcher support as a template, drill one
11
/
hole into the engine guard near the center
32
bottom. (See illustration) Attach catcher
support to engine guard using with four
3
/
-16 x ¾ bolts and four
8
Make sure support strap tabs are facing to the
rear.
3. Attach hanger bracket to catcher support with
5
four
/
-18 x 1 carriage bolts and four
16
nyloc nuts. See illustration.
4. Attach support straps to catcher support at the
support strap tabs, using two
head bolts and two
5. Align engine guard with attached support and
hanger bracket to rear of mower. Secure the
opposite end of the support strap and the
engine guard to the sides of the mower with
5
two
/
-18 x 1 carriage bolts and two
16
nuts.
Support Strap Tab
Catcher
Support
Engine Guard
Drill One
/
11
32
into engine guard
to match this hole
8
ASSEMBLY
3
/
-16 nyloc nuts.
8
5
/
16
5
/
-18 x 1 hex
16
5
/
nyloc nuts.
16
5
/
nyloc
16
Hanger Bracket
Support Strap
hole
2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY
NOTE: For ease of assembly, you may wish
assistance from another person for mounting the
cover assembly to mower.
1. Position cover assembly on ground behind
mower.
2. Lift and rotate cover to align the cover bracket
with hanger bracket and slide the cover down
until secure.
Frame Bracket
Hanger
Bracket
Advertisement
