Test Firing Heater & Storage - Dyna-Glo FA40 BTU Series User's Manual And Operating Instructions

PROPANE CONSTRUCTION HEATER
WARNING
: Motor and fan must be running before lighting, during operation and at shutdown,
in order to prevent a flame-out condition which could result in personal injury or property damage.
Turn gas valve knob clockwise
Turn gas supply OFF by turning Propane tank valve clockwise
Disconnect the power cord once the heater has cooled to ambient temperature.
Test fire your construction heater, following the lighting instructions applicable to the gas control sys-
tem employed. Leak test all gas connections with soap solution. Soap bubbles indicate gas leakage.
DO NOT use a match or flame to test for gas leaks.
Never store a Propane gas tank inside a building or in the vicinity of any gas or oil burning appliance.
When the Propane tank is not disconnected from the construction heater, the gas tank and heater
must be stored outdoors in a well ventilated area, out of the reach of children. If for any reason the
heater is to be stored indoors, the tank must be disconnected and stored outdoors in a well ventilated
area out of reach of children, in accordance with the standard for the the Storage and Handling of
Liquefied Petroleum Gases, ANSI / NFPA 58 and CSA B149.1, Natural Gas and Propane Installation
Code. The plastic tank valve plug supplied with your tank must be tightly installed when the tank is
disconnected from the heater.
1. Turn unit off, allow heater to fully cool and disconnect propane hose before performing any Mainte-
nance
functions. Unplug the unit from the 120V receptacle.
2. Keep unit clean and keep the inside of the torpedo housing debris free.
3. Have unit checked by a qualified technician at least once a year, preferably prior to the heating
season.
Warning: Use only original replacement
parts. This Heater must use design-specific
parts. Do not substitute or use generic parts.
Improper replacement parts could cause
serious or fatal injuries.
This will also protect your warranty coverage
for parts replaced under warranty.
Parts warranty and non-warranty: Contact
authorized dealers of this product. If they can
not supply original replacement part(s), either
contact your nearest Parts Central or GHP
Group Inc., Technical Service Department at
1-877-447-4768.
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
SHUTDOWN INSTRUCTIONS
to OFF position.
TEST FIRING HEATER
STORAGE
MAINTENANCE INSTRUCTIONS
REPLACEMENT PARTS
When calling GHP Group Inc., have ready:
•
•
•
•
•
•
to close.
your name
your address
how heater was malfunctioning
serial number of heater
model number of heater
replacement part number
10