Jumping The Battery; Replacing The Fuses - Yamaha WaveRunner VX Sport 2014 Owner's/Operator's Manual

Trouble recovery
(2) Remove any weeds or debris from
around the jet intake, drive shaft, impel-
ler, jet pump housing, and jet thrust noz-
zle.
If debris is difficult to remove, consult a
Yamaha dealer.
EJU34642

Jumping the battery

If the watercraft battery has run down, the en-
gine can be started using a 12-volt booster
battery and jumper cables.
EJU34664
Connecting the jumper cables
EWJ01251
WARNING
To avoid battery explosion and serious
damage to the electrical system:
Do not reverse the polarity of the jumper

cables when connecting to the batter-
ies.
Do not connect the negative (–) jumper

cable to the negative (–) terminal of the
watercraft battery.
Do not touch the positive (+) jumper ca-

ble to the negative (–) jumper cable.
(1) Connect the positive (+) jumper cable to
the positive (+) battery terminals of both
batteries.
(2) Connect one end of the negative (–)
jumper cable to the negative (–) battery
terminal of the booster battery.
86
(3) Connect the other end of the negative (–)
jumper cable to an engine hanger.
2 3
1
4
1 Negative (–) jumper cable
2 Booster battery
3 Positive (+) jumper cable
4 Engine hanger
(4) Start the engine, and then disconnect the
jumper cables by reversing the steps
above. (See page 27 for information on
starting the engine.)
EJU34696

Replacing the fuses

If a fuse is blown, replace it with the proper
fuse.
1
1 Good fuse
2 Blown fuse
To replace a fuse:
(1) Remove the seat. (See page 38 for seat
removal and installation procedures.)
2