Installation With Cardan Shaft; Remove The Spacer (For Version With Through Drive) - Bosch Rexroth A10VOH145 60 Series Instruction Manual

7�4�6 Installation with cardan shaft
Bring the axial piston unit to the installation position and fasten it.
Details of the required tools and tightening torque for the mounting bolts can be
obtained from the machine/system manufacturer.
NOTICE! Damage to the axial piston unit and leaks at the shaft seal due to
incorrectly installed cardan shaft!
Improperly installed cardan shafts generate unbalances. This results in vibrations
and inadmissible axial and radial forces on the drive shaft.
▶ Observe the cardan shaft manufacturer's assembly instructions.
7�4�7 Remove the spacer (for version with through drive)
Fig� 8: Removing the spacer
Axial piston units with through drive are delivered with a spacer (1).
The spacer is designed for transport protection and to reduce the hub's
axial clearance (2).
CAUTION! Operation with spacers!
Operating the axial piston unit with spacer may result in damage to the
axial piston unit.
▶ Remove the spacer prior to commissioning.
▶ Remove the spacer (1).
The spacer must be removed before the second pump is fitted. If you operate
a further axial piston unit without installing an additional pump on the through
drive, it is absolutely necessary to remove the spacer and the hub. Since the
metallic protective cover (3) is not pressure-resistant, it must be replaced with
a pressure-resistant cover. If you need a pressure-resistant cover, contact your
Bosch Rexroth Service partner. Use a suitable tool for this to prevent damage
to the functional surfaces. If functional surfaces are damaged, contact your
Bosch Rexroth service partner or the service department of the factory that
manufactured the axial piston unit.
Installation | A10VOH145 series 60
1
3
2
RE 92704-01-B/2022-12-07, Bosch Rexroth AG
33/56