Installation With Cardan Shaft; Completion Of Assembly - Bosch rexroth A4VSO 10 Series Instruction Manual

40/72 Installation
For attachment via gear
wheel or helical gear shaft
Bosch Rexroth AG, axial piston variable pump A4VSO, RE 92050-01-X-B1/2019.08.23
No gearing forces higher than the permissible axial and radial forces should act
on the shaft; if necessary, support the gear wheel at the gearbox output separately.

7.4.6 installation with cardan shaft

To connect the axial piston unit to the drive motor via a cardan shaft:
1. Place the axial piston unit near the intended installation location. Allow enough
space for the cardan shaft to fit through on both sides.
2. Place the cardan shaft on the output shaft of the drive motor.
Push the axial piston unit to the cardan shaft and place the cardan shaft on the
3.
drive shaft of the axial piston unit.
4. Bring the axial piston unit to the installation position and fasten it. Details on the
required tools and tightening torques for the mounting bolts can be obtained
from the system manufacturer if required.

7.4.7 Completion of assembly

1. Remove any installed transport screws.
CAUtion! Operation with protective plugs!
Operating the axial piston unit with protective plugs may result in injury or damage
to the axial piston unit.
▶ Before commissioning, remove all protective plugs and replace them with
suitable, pressure-resistant connecting fittings.
2. Remove the transport protection.
The axial piston unit comes with protective covers (1) and protective
plugs (2). They are not pressure-resistant and have to be removed prior
to connection. Use a suitable tool for this to prevent damage to the sealing and
functional surfaces. If sealing or functional surfaces are damaged, contact your
Bosch Rexroth service partner or the service department of the factory that
manufactured the axial piston unit.
2
3
1