Honeywell 51851 User Manual page 6

STANDARD OR ANGLE MOUNT INSTRUCTIONS
1. Remove the downrod clip and downrod pin from the downrod. Then partially loosen the two set screws in the yoke at the top
of the motor assembly (Figure 3.1).
2. Insert the downrod through the canopy and yoke cover. Feed the wire and braided cable from the fan through the downrod.
Depending on the length of downrod you use, you may need to use the 36-inch lead wire to accomodate a 36 or 48-inch
downrod (sold separately). When necessary, connect the 3-pin connector extending from the center of the downrod to one
end of the 36-inch lead wire. Note: The downrod included with this fan will not utilize the 36-inch lead wire (Figure 3.2).
3. Slide the downrod into the yoke of the motor assembly, align the holes, then re-install the downrod pin and downrod clip.
Secure with the two set screws and slide the yoke cover down until it rests on top of the motor assembly (Figure 3.3).
4. Install the ball end of the downrod into the opening of the mounting bracket. Rotate the downrod until the tab in the
mounting bracket is seated in the slot in the downrod ball (Figure 3.4). WARNING: Failure to align the slot in the ball with the
tap on the mounting bracket may cause the fan to fall, which could result in injury or death.
5. Connect the 3-pin connector from the downrod to the 3-pin connector from the receiver. Then, insert the receiver, antenna
first, into the mounting bracket with the flat side facing the ceiling. Note: The receiver will rest directly on top of the downrod.
(Figure 3.5).
Downrod Clip
Downrod Pin
Figure 3.1
Mounting
Bracket
Slot
Tab
Downrod
Figure 3.4
Set Screw
Figure 3.2
Figure 3.5
Canopy
Yoke Cover
Downrod
Mounting Receiver
Bracket
EN I 6
Downrod
Downrod Clip
Figure 3.3
Set Screw
Downrod Pin