Premium Leisure GE 630 Owner's Manual page 8

Generic hot tub
Table of Contents

Advertisement

Persons under the influence of medication, drugs, or alcohol should not be
allowed into your
Remove all jewelry, metal, and watches from your person before entering
your hot tub.
Do not allow children to use your
an adult.
Do not use your
Test the ground fault circuit interrupter (GFCI) breaker prior to using your
tub
each time to ensure it operates properly.
Any electrical devices near your
reach from inside the
Keep all breakables away from the
Lock the cover on your
Enter and exit the
Prolonged immersion can be hazardous to your health.
Maintain water chemistry in accordance with manufacturer's instructions.
The hot tub is not to be used by persons with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction
Basic Water Quality Guidelines
During the initial filling of the spa, add a sequestering agent to combat
suspended minerals in the water. Allow water to circulate and filter for at
least 12 hours before adding any other chemicals.
Test water for PH, total Alkalinity, and Calcium hardness. The PH should be
7.2-7.8 and the total Alkalinity 80-180 PPM. Calcium hardness levels should
be maintained between 150 and 400 PPM. Adjust PH and total Alkalinity
(TA) utilizing the directions on the chemical bottles. Wait 15-30 minutes, test
and adjust if necessary.
Add 2 ounces of concentrated chlorinating granules (sodium Dichlor-s-
triazinetreone) on initial start up to begin sanitizing the spa water. It is
important not to add the chlorinating granules until the PH, alkalinity and
calcium hardness have been adjusted to their proper levels.
Check spa water with test strip for proper sanitation levels and adjust
accordingly to the proper levels. Free chlorine should be 2-4 PPM.
We recommend a minimum level of 2 PPM residual chlorine be maintained
in spa water. Be sure the pumps are running when adding chlorine or non
chlorine shock/oxidizer.
Add 1 ounce of non-chlorine shock/oxidizer or ½ ounce of chlorine to the spa
water after each spa use.
hot
tub.
hot tub
alone.
hot tub
hot
tub.
hot tub
when not in use.
hot tub
slowly. Wet surfaces can be slippery.
Page 6
For HELP, call 727.573.9611
hot tub
without continuous supervision of
must be GFCI protected and out of
hot tub
area.
hot

Advertisement

Table of Contents
loading

Table of Contents