Premium Leisure GE 630 Owner's Manual page 10

The following dimensions can be used to determine the proper location of
submerged conduits in concrete slab installations. All dimensions are made from
the outside of the hot tub's frame with the access panels removed. The topside
control panel is shown at bottom of diagram for reference.
Figure 2 – Conduit Entry Location Reference Points
Table 1 – Conduit Entry Location Dimensions
10) Consider positioning your
wind. Just as people can get cold on cool/windy days, so can your hot tub.
Windy environments can significantly increase operating costs.
11) Consider using an insulating pad. In cold climates, the ground can rob heat
from the hot tub
Electrical Specifications
Important – Qualified and licensed electricians must perform all electrical
hookups. The following specifications must be followed in order to ensure proper
performance and safety.
WARNING: Starting an incorrectly wired hot tub could cause severe damage
to the mechanical equipment or even bodily harm. Have your
licensed electrician verify GFCI (or RCD) wiring with the
diagrams on pages 10-11 prior to starting the hot tub or call the
technical support line at 727.573.9611.
Caution: Failure to abide by specifications listed may result in damage to the
equipment and will void the warranty.
All hot tubs must be wired with the appropriately sized wiring. Failure to do so will
cause equipment damage and will not be covered under your warranty.
All hot tubs must be over current protected with a built-in GFCI (or RCD for
A
B
Model Dimension A
1230 26" (65 cm)
GE 630
hot tub
and increase your operating costs.
For HELP, call 727.573.9611
Topside control
Dimension B
8" (20 cm)
out of or adequately protecting it from the
Page 8