Error Messages - Pioneer HTZ-370DV Operating Instructions Manual

09 Additional information
Problem
No HDMI video output
Color problems occur
with your monitor after
changing the HDMI
Color setting (page 27).

Error Messages

Message
LINE ON
EXTRAPWR
SND. DEMO
CANNOT
MUTING
STEREO
TRAYLOCK
KEYLOCK
USB ERR
HDMI ERR
EEP ERR
EXIT
44
En
Remedy
• Make sure that you've selected this player as the HDMI input in the settings for
the component you're using (refer to the component's instruction manual).
• Check that the HDMI cable is connected properly and isn't damaged.
• Check that components connected using the HDMI interface are switched on
and HDMI compatible (components must be compatible with both DVI and High
Bandwidth Digital Content Protection (HDCP)).
• Depending on the component you have connected, using a DVI connection may
result in unreliable signal transfers.
• Make sure the resolution on this player matches that of the component you have
connected using HDMI. See Video Output settings on page 27 to change the HDMI
resolution.
• If the screen goes blank after changing the resolution, it means the you selected
a resolution incompatible with your monitor. See Resetting the HDMI connection
on page 34 to reset to the factory defaults.
• Depending on the connected equipment, some HDMI Color settings may cause
the picture to be displayed incorrectly. In this case, use the TV's own video input
settings to select RGB, if possible. Alternatively, revert to the previous HDMI Color
setting.
Description
• An operation is prohibited because the Line Out mode is on (page 32).
• You cannot adjust SFC Modes or tone controls (bass, treble, and bass boost)
when using EXTRA PWR mode.
• The sound demo is on. See General in Troubleshooting on page 41.
• An operation is prohibited because DVD/CD or USB isn't selected, headphones
are connected, or TEST TONE is pressed during disc playback.
• An operation is prohibited because the sound is muted (press MUTE).
• An operation is prohibited because the DVD/CD or USB function isn't selected.
• The tray lock is on. See General in Troubleshooting on page 41.
• The key lock is enabled. See Setting the Key Lock below.
• See Important in Using the USB interface on page 24 for more on this.
• See HDMI connection above for troubleshooting tips. See also Resetting the
HDMI connection on page 34 if the problem persists.
• Contact your Pioneer authorized service center or your dealer for servicing.
• Appears when a menu is automatically exited after a set period of inactivity.