Hyundai HD 106 Instruction Manual page 18

– Do not let the appliance in operation without supervision!
– Do not put the dryer on hot heat sources (e. g. oven, stove, radiator, etc.).
– After finishing work and before cleaning, always switch off the appliance and disconnect it
from power supply by taking the power cord connector out of the electric socket.
– Any part of the appliance must not get in contact with places sensitive to heat (e. g. eyes,
ears, neck, etc.).
– If the dryer was stored at lower temperatures, acclimatize it first, by which you remove stiffness
of the lubricating fat in bearings and mechanical resistance of the plastic parts will be kept.
– Be very careful when handling the adapter during drying (it is hot).
– The power cord must not be damaged with sharp or hot objects, open fire and it must not be
sunk into water or bent over sharp edges.
– Make sure that the power cord does not hang over the edge of the working table where
children could reach it.
– The appliance must not be used in damp or wet environment and in any environment with the
danger of fire or explosion (spaces where chemicals, fuels, oils, gases, paints and other
flammable or volatile materials are stored).
– Holes for air ventilation must not be covered. Also, do not put the dryer in the "on" position on
soft surfaces (e. g. bed, towels, sheets, carpet), the duct could get covered. Penetration of
dust, hair, threads, etc. to the duct has to be prevented.
– Do not insert or throw any objects to the holes.
– It is not permissible to adjust the surface of the extra attachment (e.g. self-adhesive paper,
foils, etc.)!
– Do not insert accessories into any body cavities.
– When the appliance is switched on for the first time, short and slight smoke can come out that
does not mean any defect and it is not a reason for claiming a defect of the appliance.
– When the appliance is overheated, the automatic heat fuse is activated and it disconnects
power supply. If it happens, switch off the appliance and unplug it from the socket. Remove
possible visible obstacles preventing air flow and let the appliance cool down.
– Disconnect the appliance from power supply right after use by unpluging the power cord from
the socket and let it cool down before storage.
– Do not wind the power cord around the appliance, this will extend life of the power cord.
– If you need to use the extension cord, it has to be incorrupted and it has to comply with the
valid standards.
– Never use the appliance for any other purpose than for the intended purpose described in
these instructions for use!
– The power cord must not be damaged with sharp or hot objects, open fire, it must not
be sunk into water or bent over sharp edges.
– Use this appliance only for the purpose for which it was designed as specified in this user's
manual. Never use the appliance for any other purpose.
– WARNING: There is a risk of injury in case of incorrect use (not in accordance with the
manual) of the appliance.
– The producer does not guarantee any loss caused by improper handling of the appliance and
its accessories (e. g. electrical accident, fire, burn, hair damage) and its guarantee for the
appliance does not apply in the case of non-compliance with the safety instructions above.
II. DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES (FIG. 1)
A – hair dryer
A1 – temperature and air flow intensity regulator
position 2 – maximum temperature and air flow intensity
position 1 – medium temperature and air flow intensity
position 0 – off
A2 – handle
A3 – hanging loop
A4 – power cord
A6 – joint (for tilting the handle when the dryer is transported or stored)
18
/ 26