Worx L1300 Owner's Manual page 21

SYMPTOM CAUSE
Environmental influences.
Landroid Vision cannot
Poor connection caused by
correctly dock with the
debris on the charging strip.
charging pile.
The QR code is sheltered.
The green light on the
charging pile turns The charging base is overheating
on before charging is or overcooling.
complete.
Obstacles, such as twigs and
branches may be lodged under
Landroid Vision.
Landroid Vision wheels
skid or repeatedly slip.
The lawn is too wet.
Low grip of Landroid Vision drive
wheels.
The slope is steeper than 30%
Landroid Vision slips out
(17
of its working area.
Recognition error.
Landroid Vision operative
system crashes when Software or display fault.
charging or on standby.
Landroid Vision fails to charge
due to over temperature pro-
Landroid Vision shuts
tection and is powered off.
off when docking in the
charging pile.
Poor connection.
There is an obstacle in the wor-
king area.
Landroid Vision stops in
The cutting height is set too low
the working area.
for the length of the grass or the
grass is too dense.
There is an inclined obstacle on
Landroid Vision flips over.
the lawn.
).
o
SOLUTION
Restart Landroid Vision.
Clean the contact pins located on the charging pile and the char-
ging strip on Landroid Vision using a cloth.
Make sure the QR code is clear and that there is nothing directly
on it or above it.
Place the charging base in a shady area or wait until it reaches
the normal temperature.
Remove objects from underside of Landroid Vision.
Exclude the wet or soft ground areas by using the magnetic strip
or by creating a non-grass pathway that is more than 50mm
wide until the lawn is dry again.
Please check the wheels are clean and free of mud in order to
have the maximum grip possible.
Exclude the sloped area by using the magnetic strip or by crea-
ting a non-grass pathway that is more than 50mm wide directly
beside the slope.
Remove the obstacle is there is one. Using the magnetic strip or
by creating a non-grass pathway that is more than 50mm wide
on the lawn edge ensure that the mower functions correctly.
Restart Landroid Vision.
Place the charging base in a shady area or wait until the tempe-
rature has cooled down.
Check the LED light on the charging pile. Check the connection
between the contact pins located on the charging pile and the
charging strip.
Remove the obstacle from Landroid Vision's working area.
Raise the cutting height and then gradually lower.
Exclude the obstacle from Landroid Vision's working area.
EN
21