Pioneer DVR-310-S Operating Instructions Manual page 48

Recording
06
• Use the number buttons to enter the PlusCode
number. (To clear the last digit entered, press
CLEAR.)
• Press REC MODE to change the recording quality
(see also Setting the picture quality/recording time on
page 43). If Manual Recording is on, then you can
also select the MN setting.
• Use the
Once, Daily or Weekly recording option.
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven't set up the guide channels (or at least
the guide channel for the PlusCode number that you
entered), the recorder will prompt you to enter the
channel number that the TV program is showing on.
Tip
• You can check the timer program settings by
pressing TIMER REC to display the timer recording
screen.
VCR Plus+ programming with the power off
You can enter a PlusCode number when the recorder is
in standby.
Important
• You can't use this feature until you have set up the
guide channels. See VCR Plus+ CH Setting on
page 73
• You can't change the recording mode.
• You can't program daily or weekly timer recordings.
1 Press 'VCR Plus+'.
The front panel display shows the current recording
mode and prompts you to enter the PlusCode number.
48
En
(cursor left/right) buttons to select the
VCR Plus+
CLEAR
ENTER
P L US CODE
2 Use the number buttons to enter the PlusCode
number.
2 9 32 4
• To clear the last digit entered, press CLEAR.
3 Press ENTER.
The display shows the timer settings:
Date Start time End time
• If CODE ERROR appears in the display, check that
the PlusCode number is correct and start again from
step 1.
• If CAN'T SET appears in the display, it means that
although you entered a valid PlusCode number, the
program has already finished.
Stopping or extending a timer recording in
progress
After a timer recording has started, you can cancel or
extend recording.
REC STOP REC
1 Press and hold REC for 3 seconds.
Only the program is canceled (the timer indicator
disappears); recording continues.
2 If you want to stop recording completely, press
STOP REC.
• To extend recording, press
extend recording in 30 minute increments.
Recording channel.
REC repeatedly to